Jumper Booster Cable | 400 Amps

All those brands that are of low quality, counterfeit, private brand, brand with very little information and history are placed in this category. Brands in ‘other’ category may have one or more of these attributes and can be revised by BatteryMAX team time to time.

Be the first to review this product

0 Rs.

Out of stock

SKU

JC-OT-400

Notify me when this product is in stock

Currently, people are looking at this product

This Jumper cable is a cost effective and affordable choice that just gets the job done. fully insulated, color coded with 400 amps capacity. Clamps are made up of hardened plastic for increased insulation. The cable is flexible and comes with box for safe and easy storage.

Skip to the end of the images gallery

Skip to the beginning of the images gallery

Details

This Jumper cable is a cost effective and affordable choice
Color Coded with Red and Black for Positive and Negative terminal respectively
400 amps capacity
Clamps are made up of hardened plastic for increased insulation.
The cable is flexible and comes with box for safe and easy storage in the trunk.

Jump Starting Procedure

Stage - 1: Preparation

Park the car with dead battery (Bad Car) next to a car with a good battery (Good Car). Shut off both engines and prop open the hoods. Unlike conventional mechanic, BatteryMAX does not recommend keeping the car engine running before attaching the leads as the high current from Good Car’s battery + Good Car’s Alternator can create severe spark and become potential cause for fire.
Identify positive and negative terminals of both batteries. This is important as making reverse connection accidently can severely damage the car circuitry and can even lead to battery explosion.

Stage - 2: Making Connection

Attach the Positive cable (Red) clamp to a positive battery terminal (+) of Bad Car.
Attach the other end of positive cable (Red) clamp to positive battery terminal (+) of Good Car.
Attach the negative cable (Black) clamp to a negative battery terminal (-) of Good Car.
Attach the other end of negative cable (Black) clamp to any metal piece (metal ground) on Bad Car. It can be any bolt on engine or any unpainted surface on car’s body under the hood.

Stage - 3: Starting

Start the Good Car. Wait one or two minutes.
Then try to start the Bad Car. If success, move to stage – 4.
If the car doesn’t start wait a few moments and repeat the above step. But this time ask your partner to increase RPM of the Good Car up to 2500 (by placing foot over accelerator pedal).

Stage - 4: Removing

For removing the clamps follow the sequence given in “Making Connection Stage” in reverse order. I.e., 4 > 3 > 2 > 1. See the diagram for elaboration.

[[ PRO TIP ]]

BatteryMAX recommends fully charging the battery after it has been jump started.
BatteryMAX recommends strictly following the steps and connecting Negative Clamp (Black) directly to the negative battery terminal of the Bad Car is NOT recommended. It may cause sparking, which can damage the battery. In the case of old flooded lead-acid batteries, there may even be an escape of hydrogen and the spark could ignite that.
If you face frequent battery discharge (once every 2 weeks or higher) on a vehicle with good alternator (charging) then it’s time to replace your car’s battery before it leaves you stranded in middle of nowhere. BatteryMAX recommends replacing batteries with new & genuine batteries only. If you want to know genuine batteries, we have available or your car then click here.